Solutions to Home Flooding

July 22, 2018

 
 

In the United States, floods are reported to be the most common natural disasters. Floods are expensive to manage, as they come along with risks of soaked walls, furniture, and carpeting. They also can ruin electronics, lighting systems, and appliances thus. Shortly after this, mold follows

To avoid floods and Its consequences You need to stay above the water. It is for this reason that you should know the flood level at your home. You can get this information by navigating FEMA’s website to see flood maps.

It is important to note that even those houses on hills might need flood proofing. On any modifications, only hire those contractors that are licensed and insured. In Addition, consult the close building department on permit requirements. Do not forget to get a flood insurance to cover up unavoidable damages

Raise and Anchor Your Outdoor Equipment

To avoid contamination to the surrounding in the case of floods, you should raise your fuel tanks, generators, and air conditioning units. Fuel tanks that are not well anchored might break free and contaminate the ground and surrounding.

Protect Your Electrical and Heating Systems

Raise your home’s switches, sockets circuit breakers, and your wiring past the flood level in your location.

Make sure that your furnace is modified, and raise water heaters or other equipment past the flood levels in that area.

Control How Water Flows Around Your Property

A good angle ground can direct water away from your house. You thus should have your house built in a manner that water turns away other than being retained. Even though your area might be prone to standing water, you can seek help from an environmental service department or a state planning official. They will give you suggestions on how best to construct or remodel your house.

Water Valve Modification

If a sewer system is flooded, it can result in a sewage backing up into a property. IBHS advises people to install an exterior or interior backflow valve to mitigate risks resulting from floods.

According to the Federal Alliance of Safe Homes (FLASH), each property needs to have gate valves.  These bring along stronger seals than check valves or flap. Gave valves open automatically enabling water to flow out. When water tries to get back in, the gate valves close.

Take Up a Major Retrofit

If your property is frequently affected by floods and moving is not an option, taking a drastic and costly measure cam to solve your problem. On this, there are three options suggested by FLASH.

First, you can raise your home on columns or plies to make the lowest floor above the ground. This, however, is a costly move.

Another approach to this is wet proofing your home. This will be achieved by installing foundation vents to enable water flow through the building other than sitting inside to result in damages. On this move, you will require a minimum of 2 vents on different walls. 100-Square-foot houses, according to Flash, need 7 square feet flood vents

Finally, you can dry-proof your home through the application of coatings and other sealants to save your walls from floods.

Last-Minute Measurers amidst Water Rise

This calls for clearing gutters down spots and drains. You also can move electronics, furniture rugs, and other valuables to upper floors or above the ground. Also, shut off electricity at the breaker panel.

A FEMA report shows that no state in the US is free from floods. It is for this reason that you need to come up with risk mitigation measures on your property. Observing the above measures and getting flood insurance will keep you away from unbearable losses.

Comments

    Leave a Reply